Proudly made in the USA | Orders ship within 3 Business Days
How to Order Custom Arrow Wraps
We can make any size you want. These charts can be used as a guide for choosing a wrap width. Due to the huge selection of arrow shafts, it is best that you measure your shafts to determine the shaft diameter, then multiply by pi (3.14) to get the wrap width needed. Choose the next size up that is available on our website so that there is no gap when installed. A little overlap is OK. If you want a specific wrap width that is not listed in our shopping cart, then make a note in the comment area in the shopping cart and we will make them that size.
Click on the Arrow Manufacturer below to find the correct sizes.
Removing Old Arrow Wraps
-
Carefully scrape off the old arrow wrap using a utility knife.
-
Remove any remaining adhesive using rubbing alcohol.
-
Make sure the shaft is completely dry before applying a new wrap.
How to Apply Arrow Wraps
-
Clean the arrow shaft thoroughly with alcohol.
-
Lay the arrow wrap face-down on a non-slip surface (a soft mouse pad works great).
-
Peel the backing off the arrow wrap.
-
Align the arrow shaft with the edge of the wrap.
-
Roll the shaft evenly over the wrap to apply it.
-
Smooth down the seam using your fingers for a secure finish.
Common Arrow Wrap Sizes & Weights
Arrow Wrap Sizes | Arrow Wrap Weights |
|---|---|
1-1/2" [1.5"] | Reflective Laminated – 30.25 grains |
1-3/8" [1.375"] | Reflective Vinyl – 24.5 grains |
1-1/4" [1.25"] – for many aluminum shafts | Laminated (4.5 mil) – 10.25 grains |
1-3/16" [1.2"] – for many fat shafts | Lightweight (2 mil) – 4.5 grains |
1-1/8" [1.125"] – for some crossbow bolts | FLO Vinyl (3 mil) – 7 grains |
1-1/16" [1.063"] – for most crossbow bolts | Laminated (5.5 mil) – 12.75 grains |
1" [1.0"] – for carbon fiber
| Vinyl (3 mil) – 7 grains |
15/16" [0.95"] – for carbon fiber | |
7/8" [0.875"] – for carbon fiber | |
3/4" [0.75"] – for carbon fiber | |
5/8" [0.625"] – for small diameter shafts | |
1/2" [0.5"] – for extra small shafts |